FUEL USAGE OF ECONOMIES

Instructions below will assist you in an economical fuel consumption.
- Avoid excessive idling rotation.
- If you have to wait a while as he parked the vehicle, turn off the engine and turn it back on if you want to
   run the car again.
- If you heat up the engine, leave the engine idling until the appointment of a needle spin temperature exceeds
   the position C.
- Avoid running the vehicle suddenly (snaps) from stop condition.
- Note the condition of the tires, adjust all tire pressures to specification.
- Check the condition of the air filter.
- Do not drive vehicle with a sudden from slow speeds.
- Keep the weight of cargo should not exceed the recommended limits.

HOW braking

Requires braking distance until the vehicle can be stopped.
Example: At the speed of 60 km / h is required braking distance of approximately 4 times farther than the required braking distance at a speed of 30 km / hr. Good braking is started when the distance between the vehicle with the cessation enough and stopped the vehicle slowly.

Warning:
- If water penetrates wet brake, braking becomes a perfect act.
- If this happens (at the time of rain / after washing the vehicle), try to brake by running the vehicle slowly while stepping on the brakes several times until the brakes work normally.

USE OF MANUAL TRANSMISSION

Running Vehicles
To start running the vehicle, press the clutch pedal and enter the transmission lever into first gear position, then release the hand brake and release the clutch pedal slowly if there is a change machine slowly press the gas pedal while releasing the clutch pedal.

Displacement of teeth.
All use syncromesh forward gear, to reduce noise when shifting. Always press the clutch pedal fully while shifting gears.

Warning:
- Reduce speed and move into a lower gear position on the road down it will help braking.
- On the slippery road conditions reduce speed before moving into low gear position.
- Before you move into reverse gear position, the vehicle must be completely stopped.
- Braking continuously will cause excessive heat and will damage the brake system.

PLEASE NOTE THAT WHILE ON CAR

Before you start the
1. Make sure the hand brake in a state of interest.
2. Place trasmisi lever in neutral position.
3. Turn on the machine as follows:
- Pull choke
- Hit the clutch pedal fully
- Starter engine without stepping on the gas pedal.
Warning: stop started the after life because it will damage the engine starter system, and never started the more than 15 seconds. If the machine is not yet live wait 15 seconds longer to start the back.

Cold or hot engine conditions:
1. Press the gas pedal a little (do not press the gas pedal suddenly)
2. Engine Starter
3. If the machine is still alive also Starer engine by stepping on the gas pedal fully.

DAILY AND WEEKLY CAR INSPECTION

Daily check:
Before running the car to do daily checks like the following
1. Make sure all the glass doors, mirrors, lights in a clean condition.
2. Check the condition of the tires.
3. Check the oil leakage.
4. Check the condition of the brake pedal.
5. Check the condition of the hand brake.
6. Check the condition of the clutch pedal.
7. Check the condition of deat belt.
8. Check warning lights and indicator lights.
9. Check the gauge condition.
10. Perikda all lighting conditions.

Weekly Inspection:
1. Engine Oil.
2. Water Radiator.
3. Rem Oil.
4. Oil power staring.
5. Glass cleaner water.
6. Battery
7. Locking system of the engine hood and trunk.

Exhaust fumes

Avoid sucking on exhaust fumes. Exhaust fumes contain carbon monoxide which can cause death. Smoke is colorless and odorless. The smoke is difficult to detect to prevent it:
1. Do notturn the the engine shut the room like a garage .
2. Do not park the vehicle with the conditions of life even if diarea open car.
3. Avoid glass windows open or there is a gap that caused exhaust fumes to enter the cabin when the engine
    chamber is alive. If required an open window, set the blower at high speed and air intake selector to
    position fresh water.
4. Always check the ventilation system to keep it working normally.
5. Check the exhaust system (exhaust) of leakage or damage.
6. Always check the cleanliness of exhaust fumes to reduce the increase in the bottom of the vehicle.

Choke SWITCH

Pull the choke switch on the engine, with a cold engine or machine was first turned on (early morning). And do not pull the choke cable is too long because it will lead to wasteful of fuel.